User guide

16 SwitchView OSD Installer/User Guide
System Control & Maintenance
The following commands are used for system control and maintenance.
Enter the command sequences to perform the actions described in the table
below.
Key Sequence Action
<CM> Kn <Enter> Sets the keyboard scan set where n is a scan set number 1-3.
<CM> MR <Enter> If you hot-plug your mouse cable, you may experience a loss
of mouse signal. Use this command to restore the signal if you
are using a PC with a standard PS/2 mouse driver.
<CM> MW <Enter> If you hot-plug your mouse cable, you may experience a loss
of mouse signal. Use this command to restore the signal if you
are using a PC with a Microsoft IntelliMouse driver.
<CM> AV <Enter> Displays the current rmware version of the processors
inside your SwitchView OSD unit. You must be either at a
DOS prompt or in a text editor/word processor to view this
information.
<CM> H1 <Enter> Changes the hot-key sequence to the default:
1. Press and hold down the ‘Num Lock’ key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the ‘Num Lock’ key.
<CM> H2 <Enter> Changes the hot-key sequence to the 1st alternate:
1. Press and hold down the ‘Num Lock’ key.
2. Press and release the asterisk (*) key on the
numeric keypad.
3. Release the ‘Num Lock’ key.
<CM> H3 <Enter> Changes the hot-key sequence to the 2nd alternate:
1. Press and hold down the ‘Control’ key.
2. Press and release the tilde (~) key.
3. Release the ‘Control’ key.
<CM> ZM <Enter> Use this command to resynchronize the mouse after a
device or computer hot-plug. Repeat, if necessary, until
synchronization is re-established.
Note: Using this command while the mouse is operating
correctly will cause the mouse to lose sync.