User guide

10
Emerge EMS Installer/User Guide
Chapter 2: Installation
11
Emerge EMS1000MP-T models
1. Attach the connector of the rst link cable to the socket labeled L1 OUT
on the Emerge EMS1000MP-T transmitter. There should be a click
when the cable is fully inserted and locked in place.
2. Attach the connectors of the remaining link cables to
the sockets labeled L2 OUT to L4 OUT, as required.
In all cases, there should be a click when
the cable is fully inserted and locked in
place.
Figure 2.8: Connecting up to four link cables to the EMS1000MP-T transmitter unit