User guide

Chapter 3: Operations 11
Computer or DVD. Selecting the Change button toggles between these two modes. If DVD or
video is being displayed, the DVD mode should be selected.
Advanced menu options
The LongView Wireless extender OSD Advanced menu allows you to fine-tune the video settings
that were established with the Auto Setup function. You may tune the horizontal and vertical
position of the video monitor window, as well as adjust the brightness and contrast of the video
image. You may also adjust the video clock phase in the LongView Wireless transmitter relative to
the video clock at your source computer to assure the cleanest, sharpest video image.
Image adjustment using the LongView Wireless extender OSD
When configuring the LongView Wireless Extender, you may use the Auto Setup function to
automatically optimize the video of your LongView Wireless extender or you may choose to
optimize the video of your LongView Wireless extender manually. When optimizing video, best
results can be obtained by displaying a fixed image on screen during the optimization process.
To optimize video automatically:
1. Activate the OSD Main menu on the receiver device by pressing and holding the left
Shift key
followed by the right
Shift key and then releasing both. You may also activate the OSD via the
mouse by right-clicking twice and left-clicking once in rapid succession.
2. Optimize the video setup of your LongView Wireless extender by selecting Auto Setup - Run.
This will automatically optimize your video setup parameters. Select Finish at the bottom to
save your OSD, keyboard and Auto Setup parameters.
-or-
Select Cancel to exit without saving changes.
3. Select Finish at the bottom of the Main OSD menu to save the mode and current dynamic Auto
Setup settings.
-or-
If you wish to exit without permanently saving changes select the Cancel button. The OSD
parameters will remain in effect until the device is powered down or a change is resolution is
detected (if dynamic Auto Setup is on).
To optimize video manually:
If your monitor image requires further adjustment after running the Auto Setup, you may use the
Advanced Setup options from the LongView Wireless extender OSD menu.
1. Activate the OSD Main menu on the receiver device by pressing and holding the left
Shift key
followed by the right
Shift key and then releasing both. You may also activate the OSD via the
mouse by right-clicking twice and left-clicking once in rapid succession.
2. Select the Advanced tab from the OSD Main menu.
3. On the OSD Advanced menu, use the fine-tuning options to make further adjustments to your
video image, as needed. Press the
Left or Right arrow keys to make adjustments for:
466A-LongviewWireless.book Page 11 Friday, April 15, 2005 9:26 AM