User guide

6 LongView Wireless Installer/User Guide
Installing a LongView Wireless Extender
Follow the procedures To install a LongView Wireless transmitter and To install a LongView
Wireless receiver to properly install your new KVM extension system.
WARNING: To reduce the risk of electric shock or damage to your equipment-
Disconnect the power from the device by unplugging the power supply from the electrical outlet.
To install a LongView Wireless transmitter:
1. Ensure that the video setting of your monitor is 1024 x 768, 800 x 600, or 640 x 480 at 60 Hz
refresh rate. Best performance will be achieved if the resolution is set to 24 bit color or higher.
2. Power down the server that will be connected to your LongView Wireless transmitter.
3. Unplug the peripherals (keyboard, mouse, monitor and speakers with built-in amplifiers, if
applicable) from your server.
Figure 2.1: LongView Wireless Transmitter Installation Example
KVM I/O
Cable
LongView
Wireless
Transmitter
Power
Cable
Server
Monitor &
Peripherals
Audio
Cable
Peripheral
Cables
Server
Speaker
Server
Monitor &
Periperhals
Power Peripheral
Cables Cable
KVM I/O
Cable
Audio
Cable
LongView
Wireless
Transmitter
466A-LongviewWireless.book Page 6 Friday, April 15, 2005 9:26 AM