Owners manual

On-Screen Display.....47
Administration Mode
TheAdministrationModeisusedforlimitingthesettingsavailabletousers,resettingtheadmin
passwordordisablingtheadminpassword.
ToenableordisableAdministrationMode,clickAdministration Modeandentertheadmin
password.YouwillneedtoexittheOSDforthissettingtotakeaffect.IfAdministration Modeis
enabled,someofthesettingsinthetabs,includingtheFirmwareUpgradeoption,willnolongerbe
availableuntiltheadministrativepasswordisentered.TodisableAdministrationMode,repeatthe
samestepsabove.
To reset the admin password:
1. ClickAdministration Mode.
2. EntertheadminpasswordandclickSettings.
3. Entertheoldpassword,thenewpasswordandclickSave.
To disable the admin password:
1. ClickAdministration Mode.
2. EntertheadminpasswordandclickSettings.
3. ClicktheDisabledradiobuttonandclickSave.
Diagnostics tab
TheDiagnosticstabismainlyusedfordebugging.TheinitialviewintheDiagnosticstabshows
VideoParametersandUSBParameters.ThesearelinksthatcanbeusedbyTechnicalSupport
fortroubleshootingvideoorUSBissues.
YoucanalsoissueresetsforthetransmitterandreceiverfromtheDiagnostictab.Thereceiver
resetoptionissimilartoapowercycle.Toresetthereceiver,clickReset Receiver.
Toresetthetransmitter,clickReset Transmitter. Theresetisequivalenttopoweringthetransmitter
offandbackon.Youmightresetatransmitteriftherewasnokeyboard/mousefunctionafter
connecting.
TheadjustvideooptionallowsyoutosettheVGAparametersofthetransmitter.
TheFirmwareUpgradeoptionisonlyavailabletoadminusers.Thisoptionallowsyoutoupgrade
thefirmwareofthereceiverfromaUSBdrive.Toupgradethefirmware,clickFirmware Upgrade
andfollowtheinstructionsonthescreen.