User guide

32 HMX Extender System Installer/User Guide

make configuration changes. To exit a menu or screen and to confirm any configuration changes

you have made, type

0 (zero) and press Enter.

Configuring Network Settings

Each HMX system component is shipped with default network settings preconfigured. You can

change the default values using the serial menu.

NOTE: IP address data can be obtained by DHCP or can be set to Static (default).

NOTE: It is recommended that you configure the network settings for the transmitter before you configure the

network settings for the HMX user station.

To configure network settings for the transmitter:

1. Press

Enter to display the serial menu. The Appliance Selection Menu displays.

2. Press

2 to access the Transmitter Menu. If the password option is enabled, you will be

prompted for a password.

3. Type the password and press

Enter. The Transmitter Main Menu will appear.

Figure 3.7: Transmitter Main Menu

NOTE: The Reset Appliance option in the Transmitter Main Menu applies only to network settings.

For Sales

& Service:

PRECO

888-842-4632