User guide

Chapter 9: Using DSView 3.0 Management Software Tools 383
Figure 9.27: Add Task Wizard - Configure SNMP Traps Window
a. Modify the state of each SNMP trap by selecting on of the following from the trap’s drop-
down menu:
• Select No Change if you wish to leave the trap on/off state to the state already configured
in the DSR switch or CPS appliance.
• Select Enable to turn the trap on.
• Select Disable to turn the trap off.
-or-
Click one of the following buttons:
•Click No Change All to use the on/off states already configured in the DSR switch or CPS
appliance for all traps.
•Click Enable All to turn all traps on.
•Click Disable All to turn all traps off.
b. Click Next.
8. The Completed Successful window will appear. Click Finish. The Tasks window will appear
including the new task.