User guide

DSView Installer/User Guide 281
Changing the linefeed settings
When connecting to devices that do not insert a carriage return in incoming or outgoing data, you
may instruct the DSView software to automatically insert a line after each line of data. This
prevents overwriting data when a new line is received.
To change the linefeed settings:
1. Select Options - Session Properties from the menu bar.
-or-
Click the Session Settings icon in the toolbar.
The Session Properties dialog box will appear.
2. Click the Terminal tab.
3. If the New Line Mode - Inbound box is checked, an inbound carriage return from the device
will be treated as if both a carriage return and a linefeed were received. If not checked, a line-
feed is not added to an inbound carriage return.
If the New Line Mode - Outbound box is checked, an outbound carriage return to the device will
always be followed by a linefeed character. If not checked, a linefeed is not sent with a carriage
return. The default value is disabled for inbound and outbound.
Enabling and disabling line wrap
When line wrap is enabled, characters wrap onto the next line when a new character is received and
the cursor is at the end of the line. When disabled, new characters will overwrite the last character
on the current line when the cursor is at the end of the line.
To enable/disable line wrap:
1. Select Options - Session Properties from the menu bar.
-or-
Table 0.1: Terminal Emulation and Type
Terminal Emulation Terminal Type
VT52 DEC-VT52
VT100 DEC-VT100
VT100+ DEC-VT100
VT102 DEC-VT102
VT220 DEC-VT220
VT320 DEC-VT320