User guide

Chapter 4: Managing Units 211
Figure 4.68: Appliance Local User Account Settings Window
2. Type a new name for the local user.
3. Use the drop-down menu to select a different preemption level (1-4) for the local user. See
User Preemption Levels on page 21 for information on preemption levels.
4. If available, use the drop-down menu to select a different access level:
• User Administrator
• Appliance Administrator
•User
5. Type a new password for the local account and then confirm the password.
6. Click Save to save your changes.
7. Click Close. The Appliances window will appear including your changes.
To assign target device access rights to a local account on a local DSR switch or
CPS appliance:
NOTE: A DSView user must have Configure Local Accounts rights specified in the Unit Access Rights window to
assign target device access rights to a local account on a DSR switch or CPS appliance.
1. From the Appliance Local User Accounts window, click on the name of a local account. Set-
tings is selected in the side navigation bar and the name of the local account appears below the
name of the DSR switch. The Appliance Local User Account Settings window will appear.