User guide

Chapter 4: Managing Units 189
10. Using the drop-down menu, specify whether or not the port should use a DTR signal. If set to
DTR, the CPS appliance will report target devices as ON if the signal given matches the state
given. Otherwise, the CPS appliance will report the target device power as OFF.
11. Using the drop-down menu, specify a power signal type that will be used for power status
monitoring of the CPS appliance port:
•CTS High
• CTS Low
•DCD High
•DCD Low
•DSR High
•DSR Low
• None
12. Click Save to save your changes.
13. Click Close. The Appliances Serial Ports window will appear.
14. Click Close. The Unit Views window will appear.
To customize the communication properties for a serial port connected to a
CPS appliance:
1. From the side navigation bar, click Appliance Settings.
2. From beneath Appliance Settings, click Ports. The Appliance Serial Ports window will appear.
3. Click on the name of a serial port. Appliance Serial Ports General Settings will appear and the
name of the port will appear under the CPS appliance in the side navigation bar.
4. From the side navigation bar, click Communication. The Appliance Serial Port Communica-
tions Settings window will appear.