User guide

188 DSView Installer/User Guide
Figure 4.51: Appliance Serial Port General Settings Window
5. Type a new name for the serial port.
6. Using the drop-down menu, specify the type of port:
• Standard Command Line Interface (CLI) - Select this port type if you wish to define the
port as a Serial connection for a local terminal.
NOTE: Only one port may be defined as a CLI port. If a second port is defined as a CLI port, the previously
defined CLI port will be changed to a Standard port.
• SPC - Select this port type if you wish to connect an SPC device to the port.
• Standard - Select this port type if you wish to access a Serial device using SSH with a
CPS appliance.
7. Using the arrow buttons, specify a time-out.
8. Using the drop-down menu, specify a CLI access character that will be used to access CLI
mode on a serial device. The (^) character represents the
Ctrl key. For example, specifying ^D
means that pressing
Ctrl-D will enter CLI mode.
9. Type a Telnet port that will be used to access the serial port. The default Telnet port is 3001.