User guide

Chapter 4: Managing Units 173
To enable or disable SNMP traps for a DSR switch or CPS appliance:
NOTE: SNMP traps may also be configured from a system task. See Managing Tasks on page 368 for
more information.
1. From the side navigation bar, click Appliance Settings.
2. From beneath Appliance Settings, click SNMP.
3. From beneath SNMP, click Traps. The Appliance SNMP Trap Settings window will appear.
Figure 4.40: Appliance SNMP Trap Settings Window
4. Modify the state of each SNMP trap by selecting one of the following from the trap’s drop-
down menu:
• Select Enabled to turn the trap on.
• Select Disabled to turn the trap off.
-or-
Click one of the following buttons:
•Click Enable All to turn all traps on.
•Click Disable All to turn all traps off.
5. Click Save to save your changes.
6. Click Close. The Unit Views window will appear.