User guide

Chapter 4: Managing Units 165
2. From the side navigation bar, click Access Rights. The Unit Access Rights window will appear.
3. Select a user in the User and User Groups list.
4. Click Reboot Appliance if you wish to allow the DSView user or members of the user group to
reboot a DSR switch or CPS appliance.
5. Click Flash Upgrade Appliance if you wish to allow the DSView user or members of the user
group to upgrade the appliance firmware of a DSR switch or CPS appliance.
6. Click Configure Appliance Settings if you wish to allow the DSView user or members of the
user group to configure settings on a managed appliance.
7. Click Configure Appliance Local User Accounts if you wish to allow the DSView user or
members of the user group to configure the account information of local users existing for the
DSR switch or CPS appliance.
8. Repeat steps 3-7 for each DSView user or user group for which you wish to change
access rights.
9. Click Save to save your changes.
10. Click Close. The Unit Views window will appear.
Modifying managed appliance settings
You use the Appliance Settings in the side navigation bar to specify or view the following network
settings for managed appliances:
• Network Settings
• Authentication Server
• SNMP settings, including enabling SNMP, the IP addresses of service managers and
destinations and community names
• Version numbers of managed appliance software and firmware
• Port management, including upgrading of DSRIQ modules, cascade switch, SPC device and
modem configuration and OSCAR authentication
• Session management, including modifying settings and viewing and disconnecting sessions
and specifying global macros
• Adding, removing and modifying local managed appliance accounts
To display the list of available appliance settings in the side navigation bar, click on a managed
appliance name in the Unit Views window and then click Appliance Settings.
Modifying DSR switch and CPS appliance network settings
Network settings are read directly from a DSR switch or CPS appliance and include, among other
settings, the IP address, subnet and gateway of the DSR switch or CPS appliance.
NOTE: The MAC address may not be modified.