User guide

Chapter 4: Managing Units 153
6. Click Save to save your changes.
7. Click Close. The Unit Views window will appear including any modifications.
Modifying unit location properties
The location properties identify the location of a unit and appear in fields in the Unit Views
windows. Assigning location properties may be helpful for quickly identifying where a particular
unit is located.
You may modify the following location properties:
• Site (country, city and so on)
• Department (R&D, support and so on)
• Location (floor, room and so on)
NOTE: Location properties are visual representations only. Defining incorrect information may cause confusion.
For example, a mistyped room number.
The location properties may be used together to provide a more detailed explanation of where a unit
is located. For example, a target device may be located at the Boston site in the accounting
department and located in room 110.
If no sites, departments or locations are available, they may be added to the DSView system. See
Managing Units Using Sites on page 296 for information on adding sites, Managing Units Using
Departments on page 303 for information on adding departments and Managing Units Using
Locations on page 308 for information on adding locations.
To modify the location properties of a unit:
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Location. The Unit Location Properties window
will appear.