User guide

150 DSView Installer/User Guide
• Telnet Session - A Telnet/SSH applet window will appear.
• Serial Session - A Telnet/SSH applet window will appear.
To change the power state of a target device:
NOTE: To change the power state, a DSView user must have power control privileges and the target must be
connected to and powered by an SPC device outlet. See Modifying unit access rights on page 161 and
Managing SPC device port settings on page 180 for more information.
1. From the side navigation bar, click Overview. The Unit Overview window will appear.
2. Click the checkbox to the left of the SPC device outlet for which you wish to change the
power state.
-or-
Click the checkbox to the left of Connection at the top of the list to select all SPC device
outlets listed in the window.
3. Click On to power up the SPC device outlets.
-or-
Click the Off to power down the SPC device outlets.
-or-
Click Cycle to cycle the power (power down and then power up) the target device connected to
the SPC device outlet.
To change the name of a managed appliance:
1. From a Unit Views window, click on a managed appliance name. Overview will automatically
be selected in the side navigation bar and the Unit Overview window will appear.
2. Type a name for the managed appliance.
3. Click Save.
4. Click Close. The Unit Views window will appear including the new name of the
managed appliance.
Modifying unit properties
A number of unit properties may be modified by clicking on a unit name in a Unit Views window,
which displays the Unit Overview Window. Clicking a link beneath Properties in the side
navigation bar will display a list of properties you may modify.