User guide

Chapter 3: DSView Server 111
To modify the properties of a Spoke DSView Server:
1. Log in to the Spoke DSView Server.
2. From the DSView 3.0 Explorer, select System in the tab bar, DSView Server in the top
navigation bar and Spoke Servers in the side navigation bar. The Spoke Servers window
will appear.
3. Click on the name of a Spoke DSView Server. The Spoke Server Network Properties window
will appear.
Figure 3.46: Spoke Server Network Properties Window
4. Type a new name for the Spoke DSView Server.
5. Type a new IP address, in standard dot notation (xx.xx.xx.xx), for the Spoke DSView Server.
6. Type a new HTTPS (SSL) port number that will used by the Hub DSView Server to
communicate with the Spoke DSView Server. The default port number is port 443.
7. Click Save to save your changes.
8. Click Close. The Spoke Servers window will appear.
NOTE: The Spoke Servers window is used to updated Spoke DSView Server configuration information on the
Hub DSView Server after the Spoke DSView Server IP address or port has been changed.