User guide

multiple dial-back phone numbers each separated by a comma. The number(s) will be
stored in the DSView software database and automatically updated on the ACS
console server.
e. In the ISDN on hook time field, specify the on hook interval in the range of 2-10
seconds. The default value is 2 seconds. The on hook interval is the amount of time
after the initial dial-up connection is dropped before the modems on the DSView
server will receive incoming calls.
NOTE: If your DSView server is on Windows, the ACS console server username and password must be configured
as a user in Windows before a dial-back connection can be established.
6. Click Save.
Email
To specify email properties:
1. Click the System tab.
2. Click Email in the side navigation bar. The DSView Server Email Server Properties
window will open.
3. Type a new address for the SMTP server that sends email notifications as a domain name or
an IP address in standard dot notation (xxx.xxx.xxx.xxx).
4. If your SMTP server requires login credentials, select Login required to access SMTP server
and type a username and password, then confirm the password.
5. Click Save to store DSView software email property information in the DSView software
database on the host.
Unit status polling
To use unit status polling:
1. Click the System tab.
2. Click Unit Status Polling in the side navigation bar. The DSView Server Unit Status
Polling Properties window will open.
3. Select Enable unit status polling.
4. Type the number of seconds to wait between polling cycles (from 30-999 seconds). The
default is 900 seconds (15 minutes). A smaller value results in greater accuracy.
5. Type the number of managed appliances that may simultaneously be polled to obtain status
information (from 1-25 units). The default is 5. A larger number results in faster speed.
6. Click Save to store unit status information in the DSView software database on the host.
76 DSView™ 4 Installer/User Guide