Manualshelf

User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850
919293949596979899100
DSView software client web browser matches the certificate configured for the user.
Certificates for users may be modified. See User certificates on page 268.
Web browser settings may need to be modified to allow users to automatically log in
using certificates; see your web browser documentation.
-or-
Check the Enable Integrated Windows
®
Authentication checkbox to automatically log
a user into the DSView software using the Windows user’s computer credentials.
Web browser settings may need to be modified to allow users to automatically log in
using Integrated Windows Authentication; see your web browser documentation.
5. To enable only DSView software clients with IP addresses entered in the Address List to
communicate with managed appliances, check the Restrict by address range checkbox. To
disable address restrictions for logging into the DSView software, uncheck this checkbox.
6. Enable or disable Allow login when user is a member of more than one authentication
service as desired. The preset value is disabled. When enabled, if a user belongs to multiple
authentication services, the DSView server uses the first authentication service found to log
the user in. When disabled, if a user belongs to multiple authentication services, the
attempt to log in to the DSView software fails.
When enabled, if a user has different access rights within each authentication service
he belongs to, the user is granted access rights based on the first authentication service
found by the DSView server. In this case, a user may be granted different access rights
at different login times.
NOTE: The Allow login when user is a member of more than one authentication service setting does not replicate to
spoke servers. It is recommended that you uniformly enable or disable this setting on each DSView hub and spoke
server.
7. Click Save to store client session information in the DSView software database on the host.
DSView software modem sessions
For more information about modem sessions, see Active modem sessions on page 202.
NOTE: Modem sessions are available on supported ACS console servers.
To specify modem session properties:
1. Click the System tab.
2. Click DSView Modem Sessions in the side navigation bar. The DSView Server Modem
Session Properties window will open.
3. Specify the following Session Timeout properties:
74 DSView™ 4 Installer/User Guide