User guide

NOTE: Only the DSView software Telnet Viewer is supported on Macintosh system clients.
To specify the serial session application:
1. Click the Profile tab.
2. Click Applications in the side navigation bar.
3. Select the radio button for the application you want to use for serial sessions.
4. If you choose 3rd Party Application, enter the path and executable name of the
application (maximum 256 characters) in the Serial Application field.
Specify any of the following parameters (up to 128 characters) in the Command Line
Arguments field. When the serial session is launched, the actual values will be
substituted.
%ADDRESS% - The IP address will be substituted.
%PORT% - The port number will be substituted.
%TNAME% - The target name will be substituted.
If the third party application does not automatically launch a command window, check
the Launch in Command Window checkbox.
5. Click Save.
Specifying a user certificate
This property may be changed only for internal authentication users. See DSView software
internal authentication service on page 88.
A user may specify a certificate if the administrator has allowed it; see the procedure below. If
the system certificate policy is enabled for user certificates (see System certificate policy and
trust store on page 52), the user certificate used at login must meet the policy requirements.
As an alternative, the administrator may specify the certificate in the user account properties.
See User certificates on page 268.
To enable user settable certificates:
NOTE: Only DSView software administrators may access this procedure.
1. Click the System tab.
2. Click Global Properties.
3. Click User Credentials.
4. Check the Allow user to set own certificate checkbox.
5. Click Save.
Chapter 4: Basic Operations 41