User guide

devices named TD1 and TD2, and TD2 is listed before TD1, the merged target
device will be named TD2.
Click Next.
5. The Confirm Target Device Merge window will open. Click Next to confirm merging the
connection paths into the specified destination target device. See Connections to Units on
page 204.
6. The Completed Successful window will open.
7. Click Finish. The Units Tools window will open.
Merging target device endpoints
As an alternative to merging target device connections one at a time, the Merge Target
EndPoints Wizard allows you to simultaneously merge multiple target devices and power
outlets. The target device endpoint is defined as the target device or power outlet at the end of
the connection path. For more information about connections, see Connections to Units on
page 204.
To merge target device endpoints:
1. Click the Units tab.
2. Click Tools in the side navigation bar. The Unit Tools window will open.
3. Click the Merge Target EndPoints icon or link. The Merge Target EndPoints window will
appear.
4. From the Available Power Devices list, select the power devices that contain power
connections to be merged with target devices and click Add.
5. Click Refresh to display a list of power connections.
6. For each power connection you wish to merge, type the name of the target device you wish
to merge with the power connection. The target device name entered must match the name
of the target device in the DSView database; target device names are case-sensitive and 1-
64 characters long.
7. Click Merge.
Using the Managed Appliance Tools
The DSView management software contains tools that allow you to perform the following
actions on a supported KVM switch or serial console appliance:
• Reboot
• Upgrade the firmware
Chapter 21: Using Tools 351