User guide

To specify a key for exiting single cursor mode:
1. Select Tools - Session Options from the Video Viewer menu or click the Session Options
button. The Session Options dialog box appears.
2. Click the Mouse tab.
3. In the Single Cursor mode field, select a key from the menu.
4. Click OK. The key will be displayed in the title bar. When single cursor mode is enabled,
pressing the specified key returns the session to regular desktop mode.
To exit single cursor mode:
Press the key identified in the title bar.
To align the mouse cursors:
NOTE: The DSView software cannot get constant feedback from the mouse, so occasionally the mouse on the
switch may lose sync with the mouse on the host system. If your mouse or keyboard no longer responds properly,
align the mouse to re-establish proper tracking. Alignment causes the local cursor to be aligned with the cursor on
the remote server. Resetting causes the appliance to simulate a mouse and keyboard reconnect at the device as if
you had disconnected and then reconnected them.
Click the Align Local Cursor button in the Video Viewer toolbar. The local cursor will align
with the cursor on the remote device.
If cursors drift out of alignment, turn off mouse acceleration in the device.
Toolbar commands
These commands may also be specified in a KVM session profile; see Toolbar profile settings
on page 294.
To specify a toolbar hide time:
1. Select Tools - Session Options from the Video Viewer menu or click the Session Options
button. The Session Options dialog box appears.
2. Click the Toolbar tab.
3. Use the arrow keys to specify the number of seconds to delay the hiding of the toolbar.
4. Click OK to save the changes and close the dialog box.
To add or remove items in the toolbar:
1. Select Tools - Session Options from the Video Viewer menu or click the Session Options
button. The Session Options dialog box appears.
2. Click the Toolbar tab.
302 DSView™ 4 Installer/User Guide