User guide

To display power device input feed information:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 118), click on the appliance name.
2. Click Appliance Settings in the side navigation bar, click Ports and then Power device in
the side navigation bar. The Power Devices Attached to Appliance window will open. (For
KVM over IP switches that have two SPC ports, one row will appear for each power
device.)
3. Click on the name of a power device.
4. Click Input Feeds in the side navigation bar. The Power Device Input Feeds window will
open.
Customizing the Power Device Input Feeds window
The following fields may be displayed in the Power Device Input Feeds window. For detailed
field descriptions, see the product documentation. Use the Customize link to add or remove
fields in the display. See Using the Customize link in windows on page 30.
• Input Feed Name
• Status - Unknown, on, off, cycling, pending off, pending on, pending cycle or no status
• Load
• Alarm Threshold - a trap will be sent if the Load value reaches the Alarm Threshold value
• Load Max - a trap will be sent if the Load value is greater than the Load Max value
• Load Min - a trap will be sent if the Load value is less than the Load Min value
To change power device input feed information:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 118), click on the appliance name.
2. Click Appliance Settings, click Ports and then Power devices in the side navigation bar.
The Power Devices Attached to Appliance window will open.
3. Click on the name of a power device.
4. Click Input Feeds in the side navigation bar. The Power Device Input Feeds window will
open.
5. Click on an input feed name. The Power Device Input Feed Settings window will open.
Some fields are read-only. For fields that can be modified, enter or select new values.
6. Click Save and then click Close. The Power Device Sockets window will open.
188 DSView™ 4 Installer/User Guide