User guide

To change service options:
1. In a Units View window containing target devices (see Accessing Units View windows on
page 118), click on a target device name.
2. In the side navigation bar, click Properties, then click Services. The Unit Services window
will open.
3. Click on a service name.
4. Enable the radio buttons to enable options, then click Save.
To remove support for a service on a target device:
1. In a Units View window containing target devices (see Accessing Units View windows on
page 118), click on a target device name.
2. In the side navigation bar, click Properties, then click Services. The Unit Services window
will open, listing the services that are supported.
3. Click the checkbox next to the services to be removed. To remove all services on the page,
click the checkbox to the left of Service at the top of the list.
4. Click Delete. A confirmation dialog box will appear.
5. Confirm or cancel the deletion.
Target Device Settings
For information about power device settings, see Power Devices on page 185.
To display a list of target devices that are attached to a managed appliance or initiate
a push/pull name operation:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 118), click on the name of an appliance.
2. Click Appliance Settings Port in the side navigation bar, then click Target Devices.
3. The Target Devices window will open.
4. To initiate a pull or push name operation (see Name Synchronization on page 141), click
the checkboxes to the left of one or more device names. To select all names on the page,
click the box to the left of Appliance Name at the top of the list.
For a pull operation, click Pull Name.
For a push operation, click Push Name.
Chapter 10: Managing Units 171