User guide

The traps must be also configured on each managed appliance using the Command Line
Interface (CLI). The address of the server running the DSView software must be configured as a
trap recipient, the proper community must be set and each desired trap must be enabled.
SNMP traps are logged in the event log file. See Displaying the Event Log on page 384. SNMP
traps may also be configured from a system task. See Task: Configure SNMP trap settings on a
managed appliance on page 364.
To change SNMP settings for a managed appliance:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 118), click on the appliance name.
2. Click Appliance Settings in the side navigation bar.
3. Consult appliance documentation for recommended SNMP settings.
Figure 10.1: SNMP configuration
Target Device Services
You may add or remove support on a target device for third party services such as Terminal
Services and VNC. Before adding support for a service, the service must be properly installed
and configured on the target device.
NOTE: DSView software supports RDP version 7, which includes support for Network Level Authentication (NLA).
Chapter 10: Managing Units 169