User guide

7. The Adding Appliances window will open while the selected managed appliances are
added to the DSView software system.
8. The Apply Configuration Template window opens.
If you want to apply a configuration template to the appliance, select a template from
the list and click Next.
-or-
If you do not want to apply a configuration template to the appliance, select None and
click Next.
NOTE: For more information about configuration templates, see Appliance Configuration Templates on page 155.
9. Click Finish.
Adding a generic appliance or an EVR1500 environmental monitor
To add a single EVR1500 environmental monitor or generic appliance:
1. Click Add in a Units View window. The Add Unit Wizard will open.
2. The Select Add Unit Procedure window will open. Click Add a single appliance, then
click Next.
3. The Select Appliance Type window will open. Select EVR1500 or Generic from the
product list, then click Next.
4. A Configure Generic Appliance Settings window will open.
a. Type the name.
b. Type either the address or the fully qualified domain name.
c. Type the Telnet port.
d. Type the web browser URL.
e. Click Next.
5. Click Finish.
Adding a target device
You may add a target device using the Add Target Device Wizard, which is described in this
section. You may also add a target device using the Attach Target Device Wizard, which is
available from a Units View window that has the topology view enabled. See Topology view
on page 116.
Chapter 8: Adding and Deleting Units 137