User guide
If you selected Use SSL in Certificate-based Trust Mode, the Certificates heading will
appear in the side navigation bar. Go to step 8.
If you selected Do Not Use SSL or Use SSL in Trust All Mode, go to step 15.
10. Click Certificates. The Authentication Service Certificate Management - LDAP window
will open and list all servers that belong to the domain. A status of Trusted indicates the
certificate is trusted, based on the certificate policy (see System certificate policy and trust
store on page 52); Untrusted indicates the certificate cannot be trusted.
11. To register certificates, click the checkbox to the left of the server IP address(es). To select
all server IP addresses on the page, click the checkbox to the left of the IP Address
heading.
12. Click Register to register the certificates. The Accept SSL Certificate window will appear.
13. Click Save to store the certificate values to the DSView software database on the host.
The Certificate Management window will open if only one certificate was selected. If
more than one certificate was selected, each will appear in order in subsequent Accept
SSL Certificate windows.
14. To unregister one or more certificates, check the checkbox to the left of the server IP
address(es). To select all server IP addresses on the page, click the checkbox to the left of
the IP Address heading.
15. Click Unregister to unregister the certificates.
16. A confirmation message box will appear. Confirm or cancel the operation.
17. Click Close. The User Authentication Services window will open.
To change user schema settings for the LDAP external authentication service:
1. Click the Users tab.
2. Click Authentication in the top navigation bar. The User Authentication Services window
will open.
3. Click the name of the LDAP service. The side navigation bar will change to include the
name of the LDAP service at the top and, below the name, the information you may define.
4. Click Schema in the side navigation bar. Users will automatically be selected and the
Authentication Service User Schema - LDAP window will open.
5. Type the Base distinguished name (DN) from which to begin searches. This is a required
field unless the Directory Service has been configured to allow anonymous search. Each
Search DN value must be separated by a comma.
6. Type the key attribute. The default value is common name (cn).
102 DSView™ 4 Installer/User Guide