User guide

76 DSView Installer/User Guide
10. The Operation In Progress window will open with the message Request In Progress Please
Wait. The configuration of the spoke server will be saved to the database of the hub server and
the spoke server’s certificates will be installed on the hub server.
11. The Completed Successful window will open when the spoke server has been added.
12. Click Finish. The Audit DSView Server Tools window will open.
To change spoke server network properties:
NOTE: Spoke server network settings may need to be modified by DSView software administrators when
network settings are changed and the the hub server did not automatically detect the changes. When changing
the network settings, ensure that a port mismatch does not occur between the hub server and the spoke server.
1. On the hub server, in the Spoke Servers window, click on the name of the spoke server whose
network properties you wish to change. The Spoke Server Network Properties window
will open.
2. Change any of the following network settings:
a. Type a new computer name to use as the spoke server.
b. Type a new address in standard dot notation (xxx.xxx.xxx.xxx) for the spoke server.
c. Type a new port number for the spoke server.
3. Click Save and then click Close. The Spoke Servers window will open.
Managing hub and spoke server certificates
When a spoke server is registered with a hub server, a certificate trust relationship is established
between the two servers. Certificate information must match on the hub server and the spoke
servers for communication to take place between the servers. If the spoke server certificate is
subsequently changed, a certificate mismatch will occur.
To display or update the certificate of a spoke server on the hub server:
NOTE: Certificates may only be viewed by DSView software administrators and user administrators.
1. On the hub server, click the System tab. DSView Server will automatically be selected in the
top navigation bar and the name of the DSView software hub server will appear at the top of
the side navigation bar.
2. Click Spoke Servers in the side navigation bar. The Spoke Servers window will open.
3. In the Spoke Servers window, click Certificate. The Spoke Server Certificate window will
open including information about the spoke server certificate (Actual Certificate) and the
certificate registered for this spoke server on the hub server (Registered Certificate).
4. The window displays the certificate on the spoke server and the certificate registered on the
hub server.
If the DSView management software cannot obtain the certificate information from the spoke
server, a message will appear at the bottom of the DSView Server Certificate - Spoke Server