User guide

Chapter 9: Using Tools 267
-or-
Uncheck Enable target devices that contain default names to be added to exclude them.
c. Select Allow target devices with the same name to be merged into a single target device if
you wish to have them merged.
-or-
Uncheck Allow target devices with the same name to be merged into a single target device
if you do not wish to have them merged.
d. Click Next.
8. The Select Firmware Files for Migration window will open. Select the file image in the
Available Firmware Files list, then click Add. The selected file will be moved to the Firmware
File To Update list. Click Next.
If needed, the firmware file may be added to the DSView software system from the Appliance
Firmware Files window (accessed by selecting the System tab, Appliance Files in the top
navigation bar, and Firmware Files in the side navigation bar).
9. The Enter in Login Credentials window will open.
a. In the Username field, enter a 3-16 character username. This username must be the same
for all CCM appliances selected for migration; otherwise, the appliance without this
username will fail to migrate.
b. The Password field is optional. If specified, the password must be 3-16 characters.
c. Click Next.
10. The Completed Successful window will open. Click Finish. The Tasks window will open
including the new task.
You may display the current progress of the Migrate Units task as it is running using the Task
Results window. To display the Task Results window, click on the name of the task in the
Tasks window.
11. Repeat steps 1-9 for each type of CCM appliance that you wish to migrate.
Units successfully migrated into your DSView software system will appear in Unit Views windows
and the Migration Status field for these units will contain Migration Complete.
Task: Sending an IPMI chassis control command to target devices
This command powers up, powers down, cycles the power (power down and then power up),
performs a gentle shutdown or resets one or more IPMI 1.5 target devices.
You must have Control Target Device Power rights to send an IPMI chassis control command. See
Changing Unit Access Rights on page 102 for more information.
To add the task:
1. In the Tasks window, click Add. The Add Task Wizard will appear. Click Next.
2. The Select Task to Add window will open.
a. Select Send IPMI chassis control command to target devices from the drop-down menu.