User guide

Chapter 9: Using Tools 261
2. The Select Task to Add window will open.
a. Select Configure SNMP trap settings on appliance from the drop-down menu.
b. Type a 1-64 character name for the task.
c. Click Next.
3. The Select When to Run the Task window will open. Select a time to run the task (see
Specifying when to run tasks on page 257 for more information), then click Next.
4. The Select Unit Group window will open. Select All Appliances or select a unit group, then
click Next.
5. The Select Appliance Type window will open. Select the type of managed appliance for which
to configure SNMP traps, then click Next.
6. The Select Appliances window will open. Depending on the selections made in step 4, the
Available Appliances list will contain all managed appliances available from the unit group
specified or all managed appliances.
a. Select the managed appliance. Multiple managed appliances may be selected by pressing
Ctrl or Shift while clicking on the managed appliance names.
b. Click Add. The unit(s) will be moved to the Appliances to Configure list.
c. Click Next.
7. The Configure SNMP Traps window will open.
a. Change the state of each SNMP trap by selecting on of the following from each trap’s
drop-down menu:
• No Change - leaves the trap on/off state to the state already configured.
• Enable - turns the trap on.
• Disable - turns the trap off.
-or-
Click one of the following buttons:
• No Change All - uses the on/off states already configured.
• Enable All - turns all traps on.
• Disable All - turns all traps off.
b. Click Next.
8. The Completed Successful window will open. Click Finish. The Tasks window will open,
including the new task.
Task: Power control a target device
This task powers up, powers down or cycles the power (power down and then power up) of one or
more target devices.
To add the task:
1. In the Tasks window, click Add. The Add Task Wizard will appear. Click Next.