Manualshelf

User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850
131132133134135136137138139140
120 DSView Installer/User Guide
To change the PPP settings for a CPS or CCM appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click Ports. The Appliance Serial
Ports window will open.
5. Click CLI in the side navigation bar. Settings will automatically be selected in the side
navigation bar and the Appliance CLI Port Settings window will open.
6. Click PPP in the side navigation bar. The Appliance CLI PPP Settings window will open.
7. Click PPP Enabled to enable a modem connection to a serial device using the appliance serial
CLI/console port.
-or-
Do not select the checkbox if you wish to use the CLI/console port with the local terminal.
8. In the Local IP Address field, type the IP address, in standard dot notation (xxx.xxx.xxx.xxx),
to be used with a PPP session to the appliance.
9. In the Remote IP Address field, type the IP address, in standard dot notation
(xxx.xxx.xxx.xxx), to be assigned to the PC dialing into the PPP connection on the appliance.
10. Type a subnet mask, in standard dot notation (xxx.xxx.xxx.xxx), on which both the local IP
address and remote IP address must reside.
11. Click Save and then click Close. The Unit Views window will open.
To change the NFS port settings for a CCM appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click Ports. The Appliance Serial
Ports window will open.
5. In the side navigation bar, select a port. Then select NFS History File in the side navigation bar
and the Appliance NFS Port Settings window will open.
6. To enable NFS history file operations on that port, click Enable NFS History File.
If you enable NFS history file operations on the port, you may optionally enter a name in the
History File field. (This name is appended to the name of the mount point configured for the
CCM appliance to yield a full pathname.) You may use special characters to indicate the file
date; see the CCM Installer/User Guide.