Manualshelf

User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850
131132133134135136137138139140
116 DSView Installer/User Guide
7. Type a new total minimum amp load for the SPC or use the arrow buttons to specify a
new value.
8. Type a new total maximum amp load for the SPC or use the arrow buttons to specify a
new value.
9. Type a polling rate in milliseconds, or use the arrow buttons to specify a new value.
10. Click Save and then click Close. The SPC Devices Attached to Appliances window will open.
11. Click Close. The Unit Views window will open.
To display or customize SPC device outlet settings:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click Ports and then click SPC.
The SPC Devices Attached to Appliance window will open.
5. Click on the name of an SPC device. Settings will automatically be selected in the side
navigation bar and the SPC Settings window will open. The name of the outlet and SPC device
will also appear under the supported managed appliance name in the side navigation bar.
6. Click Sockets in the side navigation bar. The SPC Sockets window will open.
If you change the IP address of a managed appliance that is attached (in this case) to an SPC
device, the managed appliance may need rebooting. In this case, a Reboot Required icon will
be displayed in the top left corner of the SPC Sockets window. Click the icon to reboot the
managed appliance.
7. Click on an SPC socket. The SPC Socket Settings window will open and the name of the
socket will appear under the SPC device in the side navigation bar.
8. Type a new name for the socket.
9. From the drop-down menu, specify the minimum amount of time that the SPC socket should
be powered up.
10. From the drop-down menu, specify a minimum amount of time that the SPC socket should be
powered down.
11. From the drop-down menu, specify whether you wish to enable wake-up for the SPC
device outlet.
12. Click Save and then click Close. The SPC Sockets window will open.
13. Click Close. The SPC Devices Attached to Appliance window will open.
14. Click Close. The Unit Views window will open.
To power up, power down or cycle the power of an SPC device outlet:
1. Click Units in the tab bar.