User guide

Chapter 4: Managing Units 111
To enable or disable SNMP traps for a managed appliance:
NOTE: SNMP traps may also be configured from a system task. See Managing Tasks on page 255 for
more information.
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click SNMP and then Traps. The
Appliance SNMP Trap Settings window will open.
5. Select one of the following from the drop-down menu:
Enabled to turn a trap on or Disabled to turn a trap off.
-or-
Enable All to turn all traps on or Disable All to turn all traps off.
6. Click Save and then click Close. The Unit Views window will open.
To display version information for a managed appliance:
NOTE: This procedure is valid for the following managed appliances: DS1800 digital switches, DSI5100
appliances, CPS appliances, CCM appliances and DSR switches.
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then Versi on s. The Appliance Version
Information window will open, containing the following information:
• For DS1800 digital switches and DSR switches - application, boot and Video FPGA
• For DSR switches (except the DSR4160 switch) - may include application, boot, Video
FPGA, matrix FPGA, UART FPGA, digital/application, digital/digitizer, digital/FPGA
and OSCAR FPGA
• For DSI5100 appliances - DSI5100 application and boot versions
• For CPS and CCM appliances - bootstrap and application versions
5. Click Close. The Unit Views window will open.
Managing and changing port settings
To display DSRIQ module information:
1. Click Units in the tab bar.