User guide

110 DSView Installer/User Guide
4. Click Appliance Settings in the side navigation bar and then click SNMP. System will
automatically be selected in the side navigation bar and the Appliance SNMP System Settings
window will open.
5. Select Enabled in the Enable SNMP drop-down menu to enable logging of SNMP traps.
6. Change the name and description of the managed appliance and type a contact.
7. Click Save and then click Close. The Unit Views window will open.
To enable or disable SNMP manager settings for a managed appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click SNMP and then Managers.
The Appliance SNMP Manager Settings window will open.
5. Type the IP addresses, in standard dot notation (xxx.xxx.xxx.xxx), for up to four
SNMP managers.
6. Click Save and then click Close. The Unit Views window will open.
To specify SNMP community settings for a managed appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click SNMP and then Community.
The Appliance SNMP Community Settings window will open.
5. Type the SNMP community names for reading, writing and SNMP traps.
6. Click Save and then click Close. The Unit Views window will open.
To specify SNMP destination settings for a managed appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click SNMP and then
Destinations. The Appliance SNMP Destination Settings window will open.
5. Type the IP addresses, in standard dot notation (xxx.xxx.xxx.xxx), for up to four
SNMP destinations.
6. Click Save and then click Close. The Unit Views window will open.