User guide

108 DSView Installer/User Guide
d. Choose the log file rotation type by enabling one of the radio buttons Do not rotate.
Append data to end of file or Create new file each day at midnight.
6. Click Save and then click Close. The Unit Views window will open.
The NFS Status section of the Appliance NFS Settings window may contain one of the values
described in Table 4.3.
To display NTP status or change the NTP settings for a CCM appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click NTP. The Appliance NTP
Settings window will open.
5. To enable NTP on the appliance, click the Enable NTP checkbox. To disable NTP, uncheck it.
When you enable NTP, you may also configure the following information:
Table 4.3: CCM Appliance NFS Status Values
Status Description
Not mounted NFS is not currently enabled.
Mounted NFS is currently enabled and is currently successfully mounted.
Mounting
NFS is currently enabled and the mount is being attempted for the first time.
The mount has not yet succeeded or failed.
Mount attempt
failed (retrying)
NFS is currently enabled, but a mount failure has occurred and the mount is
currently being retried.
Mount attempt failed
(no longer retrying)
NFS is currently enabled, but a mount failure has occurred and the CCM
appliance was not able to establish the mount after performing the maximum
number of retries allowed. The CCM appliance has stopped trying to establish
this mount.
Mount lost (retrying)
NFS is currently enabled and was successfully mounted, but a mount failure
subsequently occurred. The mount is currently being retried. *
Mount lost (no
longer retrying)
NFS is currently enabled and was successfully mounted, but a mount failure
subsequently occurred. The CCM appliance was not able to reestablish the
mount after performing the maximum number of mount retries allowed. *
Verifying existing mount
NFS is currently enabled and was successfully mounted. Another NFS Enable
command was entered without changing any parameters, which triggered a
mount verification, which is still in progress.
* An error message accompanying the status identifies the reason for the mount failure. See the CCM
Installer/User Guide for more information.