Manualshelf

User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850
121122123124125126127128129130
Chapter 4: Managing Units 107
more information. (When changing an IP address, always change it in the Appliance Network
Settings window before changing it in the Unit Network Properties window.)
6. Type a subnet, in standard dot notation (xxx.xxx.xxx.xxx).
7. Type a gateway, in standard dot notation (xxx.xxx.xxx.xxx)
8. Use the drop-down menu to specify a LAN speed. This network setting will not appear for
CPS appliances.
9. Use the drop-down menu to enable or disable DHCP or BootP (DS1800 digital switches and
DSR switches).
10. Use the drop-down menu to enable or disable ICMP ping reply.
11. Click Save and then click Close. The Unit Views window will open.
To change the IP addresses of authentication servers:
NOTE: Except as noted, this procedure is valid for the following managed appliances: DS1800 digital switches,
CPS appliances, CCM appliances and DSR switches.
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click Authentication Servers. The
Appliance Authentication Servers Settings window will open.
5. Type an IP address, in standard dot notation (xxx.xxx.xxx.xxx), for up to four
authentication servers.
6. Click Save and then click Close. The Unit Views window will open.
To display NFS status or change the NFS settings for a CCM appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click NFS. The Appliance NFS
Settings window will open.
5. To enable NFS on the appliance, click the Enable NFS checkbox. To disable NFS, uncheck it.
When you enable NFS, you may also configure the following information:
a. Type an address in the NFS Server field.
b. Type the mount point in the NFS Mount Point field.
c. Select the protocol to be used from the Protocol drop-down menu.