User guide

106 DSView Installer/User Guide
6. Click Save and then click Close. The Unit Views window will open. If enabled, a KVM
Session, Virtual Media Session or Serial Session link will appear in the Action column. If
enabled, a power control option will appear in the Unit Overview window.
Changing Managed Appliance Settings
You may display and change the following settings for a DS1800 digital switch, CPS appliance,
CCM appliance or DSR switch:
• Network settings
• Authentication server
• NFS settings and status (CCM appliances only)
• NTP settings and status for (CCM appliances only)
• SNMP settings, including enabling/disabling SNMP, the IP addresses of service managers and
destinations and community names
• Version numbers of software and firmware
• Port management, including upgrading of DSRIQ modules, cascade switches, SPC devices
and mode OSCAR interface authentication
• Session management, including changing settings, viewing and disconnecting sessions and
specifying global macros
• Adding, removing and changing the local CPS or CCM appliance or DSR switch account
The following appliance settings may be modified for a DSI5100 appliance:
• Version number of the hardware and firmware
• Appliance port management, including adding and deleting BMCs
NOTE: The MAC address may not be modified.
To change the network settings of a managed appliance:
NOTE: Except as noted, this procedure is valid on the following managed appliances: DS1800 digital switches,
CPS appliances, CCM appliances and DSR switches.
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar. The Unit Views - Appliances - All window
will open.
3. Click on the appliance name.
4. Click Appliance Settings in the side navigation bar and then click Network. The Appliance
Network Settings window will open.
5. Type an IP address, in standard dot notation (xxx.xxx.xxx.xxx). If you change the IP address
of an appliance in the Appliance Network Settings window, you must then also change the
address in the Unit Network Properties window. See Changing Unit Properties on page 99 for