User guide

102 DSView Installer/User Guide
5. Click Properties in the side navigation bar and then click Network in the side navigation bar.
The Unit Network Properties window will open.
6. Type the address or the fully qualified domain name.
If you are changing the appliance IP address, you should first change it in the Appliance
Network Settings window before changing it in the Unit Network Properties window. See
Changing Managed Appliance Settings on page 106 for more information.
7. Select the DSView software server in charge of the managed appliance.
8. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the network properties of an EVR1500 environmental monitor or
generic appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar.
3. Click an appliance type in the side navigation bar, if configured.
4. Click on the appliance name.
5. Click Properties in the side navigation bar and then click Network in the side navigation bar.
The Unit Network Properties window will open.
6. Type the address or the fully qualified domain name.
7. Type a Telnet port number.
8. Type a web browser address.
9. Select the DSView software server in charge of the EVR1500 environmental monitor or
generic appliance.
10. Click Save and then click Close. The Unit Views window will open, including any changes.
Changing Unit Access Rights
Access rights indicate which users and user groups may access a unit.
Access rights also indicate which actions are allowed.
For target devices, you may specify whether a user or members of a user group are allowed to:
• Establish a serial session on target devices
• Establish a Video Viewer session on target devices
• Power up, power down or cycle the power of target devices
• Establish virtual media sessions to target devices
• Establish reserved virtual media sessions to target devices
For certain managed appliances (DS1800 digital switch, DSI5100, CPS and CCM appliances and
DSR switches), you may specify whether a user or members of a user group are allowed to:
• Reboot the managed appliance and/or disconnect sessions
• Upgrade the firmware (Flash)