User guide

Chapter 4: Managing Units 101
5. Click Properties in the side navigation bar, then click Custom Fields in the side navigation bar.
The Unit Custom Fields window will open.
6. Type the information in each of the three custom fields.
7. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the note properties of a unit:
1. Click Units in the tab bar.
2. Click Appliances or Target Devices in the side navigation bar.
3. Click a unit type in the side navigation bar, if configured.
4. Click on the appliance or target device name.
5. Click Properties in the side navigation bar and then click Notes in the side navigation bar. The
Unit Notes window will open.
6. Type description, accounting and comment information.
7. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the network properties of a target device:
NOTE: Defining incorrect information for these properties may cause network connection errors.
1. Click Units in the tab bar. Unit Views - Target Devices - All will automatically be displayed in
the side navigation bar.
2. Click on the target device name.
3. Click Properties in the side navigation bar and then click Network in the side navigation bar.
The Unit Network Properties window will open.
4. Type the address or the fully qualified domain name for the target device.
5. Type the Telnet port number to use for Telnet connections to the target device. If this field is
left blank, Telnet will not be enabled for the target device.
6. Type the URL for a web browser connection to the target device.
7. Select the DSView software server that is in charge of the target device.
8. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the network properties of a managed appliance:
NOTE: This procedure is valid for the following managed appliances: DS1800 switches, DSI5100 appliances,
CPS appliances, CCM appliances and DSR switches.
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar.
3. Click an appliance type in the side navigation bar, if configured.
4. Click on the appliance name.