Manualshelf

User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850
111112113114115116117118119120
100 DSView Installer/User Guide
3. Click a unit type in the side navigation bar, if configured.
4. Click on the appliance or target device name.
5. Click Properties in the side navigation bar. Identity will automatically be selected and the Unit
Identification Properties window will open.
6. Type a part number, serial number, model number and/or asset tag number.
7. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the unit location properties:
NOTE: Location properties are visual representations only. Defining incorrect information may cause confusion
(for example, a mistyped room number).
1. Click Units in the tab bar.
2. Click Appliances or Target Devices in the side navigation bar.
3. Click a unit type in the side navigation bar, if configured.
4. Click on the appliance or target device name.
5. Click Properties in the side navigation bar and then click Location in the side navigation bar.
The Unit Location Properties window will appear.
6. Type or use the drop-down lists to select the site, department and/or location where the unit
is located.
7. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the contact properties of a unit:
NOTE: Contact properties should be kept up-to-date.
1. Click Units in the tab bar.
2. Click Appliances or Target Devices in the side navigation bar.
3. Click a unit type in the side navigation bar, if configured.
4. Click on the appliance or target device name.
5. Click Properties in the side navigation bar and then click Contacts in the side navigation bar.
The Unit Contacts window will open.
6. Type the names and phone numbers of the primary and secondary contacts.
7. Click Save and then click Close. The Unit Views window will open, including any changes.
To change the custom fields of a unit:
1. Click Units in the tab bar.
2. Click Appliances or Target Devices in the side navigation bar.
3. Click a unit type in the side navigation bar, if configured.
4. Click on the appliance or target device name.