User guide

Chapter 4: Managing Units 97
5. Select a new icon for the target device using the arrows.
6. Click Save and then click Close. The Unit Views window will open, including the new
information for the target device. If you added a type that was not previously defined, it will
appear under Target Devices in the side navigation bar.
To start a session with a target device from the Unit Overview window:
1. Click Units in the tab bar. Unit Views - Target Devices - All will automatically be selected in
the side navigation bar.
2. Click on the name of a target device. The Unit Overview window will open.
3. Click on the icon or name of the session type you wish to start.
To change the power state of a target device:
NOTE: A user must have power control privileges and the target device must be connected to and powered by
an SPC device outlet.
1. Click Units in the tab bar. Unit Views - Target Devices - All will automatically be selected in
the side navigation bar.
2. Click on the name of a target device. The Unit Overview window will open.
3. Click the checkbox to the left of the SPC device outlet for which you wish to change the
power state.
-or-
Click the checkbox to the left of Connection at the top of the list to select all SPC device
outlets listed in the window.
4. Click On to power up the SPC device outlets.
-or-
Click Off to power down the SPC device outlets.
-or-
Click Cycle to cycle the power (power down and then power up) on the target device
connected to the SPC device outlet.
To change the name of a managed appliance:
1. Click Units in the tab bar.
2. Click Appliances in the side navigation bar and then click on the type of appliance.
3. Click on the name of an appliance. The Unit Overview window will open.
4. Type a name for the managed appliance.
5. Click Save and then click Close. The Unit Views window will open, including the new name of
the managed appliance.