User guide

96 DSView Installer/User Guide
• Target Devices - This window contains the name, type and icon associated with the target
device. You may also use this window to connect to the target device. The available connec-
tion methods are determined by the type of target device.
Power information appears only if the target device is connected to an SPC device outlet and
the user has power control rights. In this case, the user may power up, power down or cycle the
power of the target device.
• Target Devices with a DSI5100 IPMI connection - This window contains the name, type and
icon associated with the IPMI 1.5 target device, the power state of the target device chassis
power and tools that may be used to:
• Start an IPMI session with the IPMI 1.5 target device.
• Perform a hard reset of the IPMI 1.5 target device.
• Turn the identity light emitting diode (LED) on the IPMI 1.5 target device on or off. If the
BMC does not have a fixed interval, the LED will turn on or off for 45 seconds.
• Power up, power down, cycle the power or perform a graceful shutdown of the IPMI 1.5
target device.
Other icons may appear, based on connections to other units.
• Managed appliances - This window contains the name and type of managed appliances and the
tools that may be used to:
• Reboot
• Upgrade firmware
• Resynchronize
• Save or restore the configuration (valid only for DS1800 digital switches, CPS and CCM
appliances and DSR switches)
• Save or restore the user database (valid only for CPS and CCM appliances and certain
DSR switches)
The available tasks depend on the type of managed appliance and the user’s rights on the
managed appliance.
• EVR1500 environmental monitor or generic appliance - This window contains the name and
type of EVR1500 environmental monitor or generic appliance and links for establishing a con-
nection to it.
NOTE: The Type field of managed appliances cannot be modified.
To change target device overview information:
1. Click Units in the tab bar. Unit Views - Target Devices - All will automatically be selected in
the side navigation bar.
2. Click on the name of a target device. The Unit Overview window will open.
3. Type a name for the target device.
4. Type a new type for the target device.