User guide

94 DSView Installer/User Guide
a. Click Enable secure mode if you want the managed appliance to only be accessible by this
DSView software system. In non-secure mode, the managed appliance may be added to
multiple DSView software systems.
This checkbox will not appear when adding a DSI5100 appliance, which may only be
added in Secure mode.
This checkbox will not appear when adding a CCM appliance that is using firmware
compatible with AVWorks software. The option will be displayed when the appliance is
migrated to DSView software (see Task: Migrating AVWorks software CCM appliances
to DSView software compatible units on page 265).
b. Click Allow target devices that contain default names to be added if you wish to add any
target devices whose port names have not been modified from the factory defaults of the
managed appliances.
This checkbox has no effect when adding a DSI5100 appliance, since default target device
names are not supported. A target device is named when it is added as a BMC port using
the Add IPMI BMC Wizard.
c. Click Allow target devices with the same name to be merged into a single target device if
you wish to merge a target device that has multiple connections into a single target device.
For example, a target device may be connected to a both a DSR switch and an SPC device
outlet connected to a CPS appliance.
d. Click Next.
7. The Adding Appliances window will open while the selected managed appliances are added to
the DSView software system.
8. The Completed Successful window will open.
When you add a CCM appliance that is using firmware compatible with AVWorks software,
you will be alerted that it must be migrated, along with a link named Add Migration Task,
which will take you to the Add Task Wizard.
9. Click Finish.
To add a single EVR1500 environmental monitor or generic appliance:
1. Click Add in a Unit Views window. The Add Unit Wizard will open. Click Next.
2. The Select Add Unit Procedure window will open. Click Add a single appliance, then
click Next.
3. The Select Appliance Type window will open. Select EVR1500 or Generic from the product
list, then click Next.
4. A Configure Generic Appliance Settings window will open, including the name of the
EVR1500 environmental monitor or generic appliance.
a. Type the name.
b. (Optional) Type either the address or the fully qualified domain name.
c. (Optional) Type the Telnet port.