User guide
Chapter 4: Managing Units 93
d. In the Password field, type a 1-64 character password to be used to log in to the embedded
appliance. Passwords are case sensitive.
e. Click Next.
f. The embedded device discovery will verify that the embedded appliance’s product ID
matches the appliance type. If successful, the Select Options window will open.
g. The Appliance Name field contains the name stored in the embedded appliance. You may
change this to a 1-256 character unique name. Names are not case sensitive.
h. Enable or disable the Allow target devices with the same name to be merged into a single
target device checkbox.
i. Click Next.
8. The Completed Successful window will open.
9. Click Finish.
To add a managed appliance from a range of IP addresses:
NOTE: This procedure is valid for the following managed appliances: DS1800 digital switch, DSI5100 appliance,
CPS appliance, CCM appliance or DSR switch.
1. Click Add in a Unit Views window. The Add Unit Wizard will open. Click Next.
2. The Select Add Unit Procedure window will open. Click Discover appliances on the network
from an IP address range, then click Next.
3. The Type in Discover IP Address Range window will open.
a. Type the IP address in standard dot notation (xxx.xxx.xxx.xxx), from which to begin
the search.
b. Type the IP address in standard dot notation (xxx.xxx.xxx.xxx), at which to end
the search.
c. Click Next.
4. The DSView software will search for managed appliances within the IP address range. When
the search is completed, the Select Appliances to Add window will open, listing the results.
5. Specify the managed appliance(s) you wish add:
a. Select a managed appliance in the Appliances found list. Multiple managed appliances
may be selected by pressing
Ctrl while clicking on the managed appliance names.
b. Click Add. The managed appliance(s) will be moved to the Appliances to Add list.
To remove selected managed appliances, select the managed appliance you wish to
remove from the Appliances to Add list (multiple managed appliances may be selected by
pressing
Ctrl while clicking on the managed appliance names) and then click Remove. The
managed appliances will be moved to the Appliances found list.
c. Click Next.
6. The Select Options window will open.