User guide

ManualsBrandsAvocent ManualsComputer equipmentEquinox Console Manager CCM4850 CCM4850 CCM4850

101

102

103

104

105

106

107

108

109

110

90 DSView Installer/User Guide

Click No, the <Managed Appliance Type> does not have an address if the managed appliance

does not have an existing address. Continue to step 5.

-or-

Click Yes, the <Managed Appliance Type> does have an address and either type the address

or the fully qualified domain name for the managed appliance. Go to step 7.

5. The Configure Appliance Network Settings window will open.

a. Type the IP address and subnet mask, in standard dot notation (xxx.xxx.xxx.xxx), for the

managed appliance.

b. Optionally, type a gateway in standard dot notation (xxx.xxx.xxx.xxx).

c. Click Next.

6. The Select Appliance to Add window will open. Select the entry, then click Next.

7. The Select Options window will open. (This window will not appear when adding a CCM

appliance that is using firmware compatible with AVWorks software; see Task: Migrating

AVWorks software CCM appliances to DSView software compatible units on page 265 for

more information.)

a. Click Enable secure mode if you want the managed appliance to only be accessible by

this DSView software system. In non-secure mode, the managed appliance may be added

to multiple DSView software systems.

This checkbox will not appear when adding a DSI5100 appliance, which may only be

added in Secure mode.

b. Click Allow target devices that contain default names to be added if you wish to add any

target devices whose port names have not been modified from the factory defaults of the

managed appliance.

This checkbox has no effect when adding a DSI5100 appliance, since default target device

names are not supported. A target device is named when it is added as a BMC port using

the Add IPMI BMC Wizard.

c. Click Allow target devices with the same name to be merged into a single target device if

you wish to merge a target device that has multiple connections into a single target device.

For example, a target device may be connected to a both a DSR switch and an SPC device

outlet connected to a CPS appliance.

d. Click Next.

If you are adding a DS1800 digital switch, CPS or CCM appliance or DSR switch,

continue to step 8.

-or-

If you are adding a DSI5100 appliance, go to step 9.

8. If one or more cascade switches are connected to the managed appliance, the Configure

Cascade Switches window will open.