User guide

88 DSView Installer/User Guide
The NEC IPF embedded unit has nine target ports and one appliance for each embedded appliance.
Port names default to “Blade” plus the port number.
The Compaq iLO embedded unit has one target device.
In the DSView software, each of these appliance types will contain specific information about the
target as well as the embedded appliance itself. All KVM connections are initiated through the
target port/device.
After an embedded appliance type is added to the DSView software, an appliance type is added
under the Appliances link in the side navigation bar.
Updating firmware, changing device settings and rebooting embedded units must be done
manually. See the embedded units’ documentation for further information.
Launching embedded unit sessions
From the Target Devices window, users may launch a KVM or browser session to the embedded
devices. Each session is handled by the embedded unit and is launched in a separate window
browser. Compaq iLO, NEC IPF, IBM ASM RSA II and DRAC 4 viewers are proprietary to their
owners, and the DSView software has little control of their look, feel and configuration.
There is no status polling for these sessions (status is idle by default); nor are there connection
types. All embedded KVM browsers have their own certificate authentication. Users must accept
certificate authentication to launch embedded unit video sessions.
Users must manually close the window to close a session. In all cases, exiting or logging out of the
DSView software will not shut the KVM/browser session.
• The DRAC 4 KVM session launches a standalone launch browser which in turn launches a
KVM applet. To leave the session, the user must exit the KVM session applet and the standal-
one launch browser.
• The IBM ASM RSA II KVM session launches a KVM session applet within a browser. To
leave the session, users must exit the KVM browser session.
• The NEC IPF KVM session launches a standalone KVM session applet. To leave the session,
users must exit the standalone KVM session.
• The Compaq iLO session will launch a browser session to the login page of the embedded
device server. Users must log in to the web server to access the target device’s KVM session.
To leave the session, users must exit the KVM browser session.
See the embedded units’ documentation for further information.
Adding Units
You may add:
• A single managed appliance
• A single embedded appliance
• Multiple managed appliances based on a range of IP addresses