User guide

Chapter 4: Managing Units 85
for a power status for both of these connections. If both connections do not reply with ON
or OFF, the power status will display as Partial Power.
The Not Responding status ID may display for managed appliances only. In this case, the
managed appliance did not provide status information. This may occur for multiple reasons,
such as the appliance is not powered up or it is disconnected from the DSView
software system.
An icon appears to the right of the Name column to represent the status of a unit. Figure 4.1
lists and describes the status icons that may appear.
• Action - Type of session that may be initiated. Although an EVR1500 environmental monitor,
generic appliance or target device may have multiple actions that may be performed (for exam-
ple, a target device may be able to open using a browser session and a Telnet session), only one
action will appear in the Action column. The action that appears is based on the precedence of
the action, which is determined by the software, and whether the action is valid on the unit.
For example, a target device that is only attached to a CCM appliance will not contain a KVM
Session link in a Unit Views window. If a target device has a connection to both a CCM
appliance and a DS1800 digital switch or DSR switch, a KVM Session link will appear.
As shown in Figure 4.2, other available actions may be accessed by clicking the Alternate
Actions arrow to the right of the action with the highest precedence. Clicking on one of the
displayed links will launch the corresponding window type.
Table 4.1: Unit Status Icons
Icon in Name Field Description in Status Field Displays for
In Use Units
Not Responding Managed Appliances
No Power Target Devices
KVM Blocked Target Devices
Partial Power Target Devices
Status Unknown Units