User guide

Specify any of the following parameters (up to 128 characters) in the Command Line
Arguments field. When the serial session is launched, the actual values will be
substituted.
%ADDRESS% - The IP address will be substituted.
%PORT% - The port number will be substituted.
%TNAME% - The target name will be substituted.
If the third party application does not automatically launch a command window, check
the Launch in Command Window checkbox.
5. Click Save.
Specifying a user certificate
This property may be changed only for internal authentication users. See DSView 3 software
internal authentication service on page 88.
A user may specify a certificate if the administrator has allowed it; see the procedure below. If
the system certificate policy is enabled for user certificates (see System certificate policy and
trust store on page 53), the user certificate used at login must meet the policy requirements.
As an alternative, the administrator may specify the certificate in the user account properties.
See User certificates on page 268.
To enable user settable certificates:
NOTE: Only DSView 3 software administrators may access this procedure.
1. Check the Allow user to set own certificate checkbox.
2. Click Save.
To specify a user certificate:
NOTE: A user may access this procedure only if a DSView 3 software administrator has allowed it.
1. Click the Profile tab. Preferences will automatically be selected in the top navigation bar.
2. Click Credentials in the side navigation bar, then click Certificate.
3. Type the path and name of the certificate or browse to the certificate location.
4. Click Save. An updated Certificate window will open.
Specifying an SSH key
A user may specify an SSH key if the administrator has allowed it.
Chapter 4: Basic Operations 43