User guide

You may disable a device thumbnail from the scan sequence. The thumbnail image remains, but
it is not updated until it is once again enabled.
When running scan mode, it is recommended that logging of the following events (enabled by
default) be disabled in the DSView 3 software system. Each thumbnail scan will result in the
logging of these events. The event log could grow to a huge size if the following events are
enabled and scan mode is run continuously for a lengthy amount of time:
Appliance Change Of State Viewer Session Stopped
Viewer Session Started Appliance Viewer Session Stopped
Appliance Viewer Session Started
Thumbnail Viewer features
Figure 19.3 shows the Thumbnail Viewer areas, and descriptions follow in Table 19.4.
Chapter 19: Using the Video Viewer 311