User guide

<username>:<target device name>@<host name or IP address of the DSView 3 server>
[spcommand]
NOTE: Enter a space between <host name or IP address of the DSView 3 server> and [spcommand].
The first part of the command will establish an SSH session to the MergePoint SP manager. If a
supported SP command is present at the end of the SSH command, the SP command will be
passed through to the service processor on the appliance. The appliance will validate and
execute the command.
For example, a command to open an SSH session to a MergePoint SP manager and execute an
SP command may look like this:
ss h -p 4122 zone1/jsmith:zone2/MG P@172.30.19.122 pow eron
For more information and a list of supported SP commands, see the documentation included
with the MergePoint SP manager.
232 DSView® 3 Software Installer/User Guide