User guide

Embedded units
Using the DSView 3 software, you may add/delete, configure/display properties, and launch
video sessions to the following versions of third party embedded units:
• IBM
®
ASM (Advanced System Management) RSA II (Remote Supervisor Adapter II) -
Version 5, Build GRE132AUS
• DRAC 4 (Dell™ Remote Access Controller) - Version 1.0, Build 06.14
• HP iLO (Integrated Lights-Out) - Version 1.20
• NEC IPF (Itanium Processor Family) - Version 0.5.1.20
For management functions (other than launching video sessions) that are not performed by the
DSView 3 software, see the documentation for the unit.
Legacy units
The following legacy units are supported in the DSView 3 software.
• DSI5100 IPMI proxy appliances
• EVR1500 environmental monitors
• DS1800 digital switches
• AutoView
®
200-4, 200-8, 400-4, 400-8, 416, 424 and 2000-AM switches (these switches
must be Flash upgraded to be added to a DSView 3 software system)
• OutLook
®
140ES, 180ES, 280ES, 1160ES, 2160ES and 4160ES switches
• Cyclades KVM/net KVM over IP switches
• Cyclades KVM/net Plus KVM over IP switches
• Cyclades TS appliances
• CCM console management appliances
• CPS810 and 1610 serial over IP network appliances
Target devices
Target devices encompass a wide range of data center components such as servers and routers
that a DSView 3 software administrator may manage virtually through the DSView 3 software
system. A target device is added automatically to your DSView 3 software system when the
supported managed appliance is added. A target device may also be added individually.
Power devices
A power device is a type of target device that can be cascaded from a managed appliance.
Chapter 1: Product Overview 7